What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
Last Updated: 17.06.2025 03:36

Because the load is inductive, the current lags the voltage.(by a bit).
The third is lightning and “how it gets conducted into a home.”
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
what exactly is a ‘surge’ protector?
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
2024–10–14 [Omar Gharbi Omar Gharbi ]
(Dc diagram shown, AC is similar).
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
This one hit behind the barn.
Is anal sex allowed in Islam? It's not written anywhere in the Quran whether it's forbidden or not.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Why do people believe that global warming is man made?
A fuse is a non-resetable over current circuit protector.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
For this case there are devices called Metal oxide varistors (MOV).
Scientists map how alcohol changes bodily sensations - PsyPost
It also is a device that limits the change in current flow.
The bolt then partially travels down the line to your home.
One is “what exactly is in a ‘surge protector’ ? ”
Why are white women so overly emotional?
He then describes the function of a fuse.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
But it can get overloaded, and no longer works.
eight
Why do White people love dogs more than humans?
2024–10–10[John johnson John Johnson ]
So, the voltage could go up to 500 volts, and the fuse will not open up.
At one ohm, the resistor has a maximum of 1 watt power.
Costco opens a whole new kind of store - TheStreet
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
nine
It seems that I am cursed with bad luck. How do I break such a curse?
One
This is the picture of an electronic coil of wire wound around a core of magnetic material.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
This is 'the assistant's answer'
the problem then depends on "how fast does the fuse operate?".
Should You Do Cardio or Weights First? We Finally Have an Answer. - ScienceAlert
a photo is worth a thousand words.
First Sentence:
These devices are installed between the “hot” and “neutral” and protective ground.
Why do flat-Earthers think the Earth is flat?
The other is “what does a “fuse” do?”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
How do I become a Buddhist, and can someone explain Buddhism to me?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
An AC voltage/ current source, and an ac inductive load.
[old diagram got deleted by accident]
What does a fuse do?
[image of Common-mode choke]
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
He then describes Rainy Season and Lightning.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is where the MOV conducts again, and dissipated the energy.
What is lightning?
Edit 2024–10.
This device then solves the entire problem.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
But… the neutral is now “floating” because of the 1 ohm resistance.
but this device (an Inductor) … impedes the rapid changes in the current.
Barnstars:
2024–10–16 [ OO OLAOYE OYEBODE ]
Upvotes:
These are simplified answers to the original question, and does not change anything I wrote above.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
so, what happens?
In schematic diagrams this is the symbol for a fuse:
Now when you have a certain ac resistance, then a current flows in a loop.
The MOV will conduct when the voltage exceeds 50% of line voltage.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
It seems Mohan does not understand the difference between a comment and an Answer.
A circuit breaker is similar, but is resettable.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Here is a simplified AC power diagram.
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
I post the exact comment here.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
but I think this circuit , shows a few more pieces.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
There are two important concepts here.
He then asserts :
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
There are three different concepts here that are getting confused.
At least they know the answer if they wanted it.